Blenderm
Tape
Are you tired of the tape coming loose on your electric
flying surfaces? This is the only tape that really works
on all of the foam airplanes for hinging. It is thin,
flexible and has a very aggressive adhesive. It stays
where you put it. Use it on all electric airplanes that
use the tape to hinge the flying surfaces with tape.
Have a roll in your tool box and you can use it as intended
to patch up cut fingers!
1" Width |
Carbon
Fiber Tubes
and Rods
Click on Image for more carbon fiber
Recommended:
060 x 36" Carbon rod
125 x 36" Carbon tube
157 x 36" Carbon tube
188 x 36" Carbon tube
118 x .019 x 36" Carbon flats
|
Foam
Safe/Oderless CA
Medium 1/2 Oz
SUPER-GOLD™
ELE-74
Foam Safe Oderless CA
SUPER-GOLD+™
Thin
1/2 Oz
ELE-72
|
Bob
Smith IC-2000™ CA
Medium 1/2 Oz
CPR-70
Rubber-toughened
cyanoacrylate that forms superior shock resistant bonds
on non-porous surfaces. The black colored CA has added
flexibility for the bonding of metals, fiberglass, rubber,
carbon-fiber and other advanced materials. For model use,
IC-2000™ is ideal for the bonding of bulkheads, formers
and servo rails to the inside of fiberglass hulls and
fuselages. Setup time is 20-40 seconds, which can be accelerated
with INSTA-SET™. When cured, IC-2000™ is pliable enough
to be carved with a hobby knife.
INSTA-CURE™ 1 Oz.
Water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs cure, they give off a vapor that can irritate the nose and eyes, so be prepared. Thin CAs work very well on balsa since they penetrate into the wood and form more than just a surface bond.
CPR-73 .
|
Ca
Activator Foam Safe
CPR-75
These
are 10 ounce cans of a great kicker. You will use it
to the bottom of the can, and that will take you a long
time. The nozzle does not plug and will spray evenly
for the entire can, not turn into a stream. It will
not evaporate while is sitting on your workbench.
I
have not found any foam that it will bother. It also
works on all Ca's. It does not make it turn to "popcorn";
it just makes it cure very quickly.
INSTA-SET™ Kicker 2 oz
BSI INSTA-SET™ CA Activator Foam Safe.
INSTA-SET™ in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. INSTA-SET™ is formulated with a strawberry scent and activates CA in 6 to 8 seconds without any degrading of the CAs strength, which can occur with many other accelerators. It is compatible with all surfaces, even clear plastic and white foam. CPR-72
|
